![]() ![]() Power it up while pressing the F2 key, it will boot into BIOS setup, navigate to the last tab ( Save & Exit), select your USB drive (should be something like UEFI: USB, Partition 1) in the Boot Override menu, press Enter key to boot it. ![]() ![]() Here are two examples for soldering a USB-A female connector, choose whatever you find more convenient:įlash a USB drive with your favorite Linux distro, I recommend using Xfce desktop environment considering the Movistar Home only has 2 GB RAM.Ĭonnect a keyboard and the drive to a USB hub and connect it to Movistar Home. Solder a micro USB female connector and connect an OTG adapter cable or just solder a cable with a standard USB-A female connector to it, then short the fourth pin (or the ID pad) to the ground (GND, the fifth pin), making the device function as an OTG host. Locate the unpopulated micro USB port on the left edge of the motherboard: Find a way to install Linux without disassembling nor soldering (maybe through easycwmp on port 7547)Ĩ-inch 1280x800 with Goodix I2C touch screenĤ omnidirectional microphones with dedicated DSPĢ1.2 x 23.5 x 12.2 cm (height x width x depth)Īs in the latest Manjaro XFCE with 5.15.76-1 kernel, on November 7, 2022: Deviceĭisassemble the device, there are 10 snap-fits under the back panel edges, be careful not to damage them then 8 screws under it, and 4 screws hidden under the rubber strip at the bottom of the device.I dumped the original Android-x86 firmware from flash, but it failed to boot after I wrote it back in, and the /data partition was encrypted and I couldn't find a way to decrypt it.Ĭontributions to the repository are very welcomed if you've got any discoveries or if you have a Movistar Home not in use and willing to help this project, please join our Telegram group chat, much appreciated! TODO list 5.7 Control display state from Home Assistant. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |